封面图
正文内容
风险分析
risk analysis
1、应用软件系列号失效风险：有些应用软件的软加密策略是基于主板系列化进行的，更换主板后因系列号不同，可能会导致原系列号失效，而应用软件不能正常使用。
1. Risk of application software serial number failure: Some application software's software encryption strategy is based on motherboard serialization. After replacing the motherboard, due to different serial numbers, the original serial number may become invalid, and the application software cannot be used normally.
2、集成板卡驱动程序失效风险：若是更换同型号主板，此风险基本上不会出现。但若是不同型号主板，更换主板后应一并安装相应板卡的驱动程序，特别是与相关硬件设备进行数据连接的相关端口、卡槽等。
2. Risk of integrated board driver failure: If the motherboard of the same model is replaced, this risk will basically not occur. But if the motherboard is of a different model, the driver program for the corresponding board should be installed together after replacing the motherboard, especially the relevant ports, card slots, etc. for data connection with relevant hardware devices.
从以上风险分析看，更换主板基本上不会影响到应用软件的功能与数据，而只是应用系统能否正常启动、硬件设备能否与电脑正常连接。
From the above risk analysis, replacing the motherboard basically does not affect the functionality and data of the application software, but only whether the application system can start normally and whether the hardware devices can connect to the computer normally.
验证内容
Verification content
1、应用软件正常启动确认
1. Confirmation of normal startup of application software
更换主板并升级相关集成板卡驱动程序后，确认相关应用软件能否正常启动。若能正常启动（不存在因许可问题而限制部分功能情况），则可确认更换主板对应用软件启动没有影响。
After replacing the motherboard and upgrading the relevant integrated board driver, confirm whether the relevant application software can start normally. If it can start normally (without limiting some functions due to licensing issues), it can be confirmed that replacing the motherboard has no impact on the application software startup.
2、数据连接确认
2. Data connection confirmation
若是更换不同型号主板，需进行硬件设备与电脑数据连接的确证。一般而言，硬件设备启动后，能通过系统自检测试的，基本上可确认数据正常连接。若没有自检功能的，可进行进行相关操作，看应用软件能否正常控制设备，同时可正常输出相关结果。
If replacing a different model motherboard, it is necessary to verify the data connection between the hardware device and the computer. Generally speaking, after the hardware device is started, it can basically confirm that the data is connected normally by passing the system self check test. If there is no self check function, relevant operations can be carried out to see if the application software can control the device properly and output relevant results normally.
一般而言，更换主板后，进行应用启动和数据连接确认即可。
Generally speaking, after replacing the motherboard, application startup and data connection confirmation are sufficient.